There are two ways to get the trunk lid you want for the next 10 years: buy a new one or replace one that’s on the shelf.
But the first is a little more complicated, and a little less fun.
Here are the steps to making the trunk lids for the 2020s easier, and more fun.1.
Pick a lid brand and size.
The bigger the lid, the easier it is to clean.2.
Clean the lid with a mild detergent.
I prefer the kind that’s formulated to kill germs.
The one I’ve been using is a liquid detergent called Clorox, but other brands will work.3.
Rinse the lid thoroughly with soap and water, and then scrub it with a soft cloth or toothbrush to remove any excess product.4.
Add a little extra product with a dampened cloth or paper towel.
This is called a mask.5.
Rub it on the outside of the lid to help it stick better.6.
Let the lid dry in the sun, with a towel or paper.
The lid is waterproof and can be used for two years.7.
Seal the lid.
When the lid is dry, you can seal it with tape or some kind of sealant.
I don’t know of any product that works as well as this.8.
Use a toothbrush or a sharp knife to cut out a small hole in the lid using a hacksaw.
This is the only way to get a trunk lid for the 2021s.
The next generation trunk lid should be the most popular, but that doesn’t mean it’s necessarily the safest.9.
Get your trunk lid ready.
First, you’ll want to make sure the lid will be a good fit.
It should have enough room for the trunk, so it won’t get too snug.
If it’s too tight, it’ll be too small.10.
You’ll also need a mask, so make sure it’s thick enough to cover the whole lid, or it won, too.
You’ll need to buy the mask yourself.
The cheapest mask I found was from Amazon for $7.50.
You can also buy masks from Home Depot, Lowe’s, or online at Amazon.